36" Chain Link Fence Fabric Stretcher Bar - Galvanized Steel

Product Description

36″ Chain Link Fence Fabric Stretcher Bar — Galvanized, Welded (Professional Grade)

• Even, Controlled Pull — 36″ welded stretcher bar grips multiple diamonds to tension fabric without distortion
• Fence-Contractor Grade — Heavy, galvanized steel construction chosen by professionals for jobsite durability
• Straightens & Aligns — Helps remove waves and align knuckles before you tie off at terminal posts
• Works with Common Mesh — Designed for typical residential and commercial chain link fabric
• Tool-Only — Use with a come-along/ratchet puller and chain (not included)

Make clean, repeatable pulls with this 36″ galvanized welded fabric stretcher bar. The welded profile spreads force across multiple diamonds so you can tension the mesh evenly, take out “snake,” and square the fabric prior to installing the tension bar and bands. Finish the run with ties and bottom tension wire; many pros pair this step with hog ring pliers and 9 ga aluminum hog rings for fast, consistent attachment.

Why Choose This

• Professional results — Wide gripping area minimizes point loading and diamond distortion
• Rugged build — Galvanized, welded steel stands up to daily field use
• Installer-friendly — 36″ length is easy to position and re-set on taller fabric
• Reliable alignment — Helps keep top/bottom rails straight and fabric plumb before tie-off

Specifications

Installation

Hook or lace the stretcher bar through the fabric along the pull edge. Attach your come-along/ratchet puller and chain to the bar near the center and to a stable anchor point on the terminal post or a temporary brace. Tension gradually, checking that the diamonds remain uniform and the fabric stays plumb. Once taut, install the tension bar and bands at the terminal post, then release the pull and complete ties and bottom tension wire. Reposition the 36″ stretcher bar as needed on taller fabric to keep the pull even from top to bottom.

Buying Guide

• Length choice: 36″ is a versatile, easy-handling size for most residential and light-commercial pulls; for very tall fabric, make multiple pulls from top, mid, and bottom.
• Pulling gear: Pair with a quality come-along or ratchet puller and a rated chain/strap.
• Finishing steps: After tensioning, secure with a tension bar and bands, then add ties along rails and bottom tension wire (hog rings and pliers speed this step).

Frequently Asked Questions

Is this the same as a “tension bar”?

No. A tension bar stays in the fence and is banded to the terminal post. This stretcher bar is a reusable tool used to pull the fabric tight before you install the tension bar.

Will it work with vinyl-coated fabric?

Yes, it’s commonly used on galvanized and color-coated fabrics. Avoid over-tensioning to prevent scuffing.

Do I need more than one on tall fences?

You can use a single 36″ bar and re-position it for top/mid/bottom pulls. Some crews use two bars to save time on tall fabric.

Does it include the puller or chain?

No—this listing is for the stretcher bar only.

Will it bend the diamonds?

Used correctly, the wide gripping area distributes load to help keep diamonds uniform. Tension gradually and evenly.

Comparison

Need help planning your pull setup or choosing finishing hardware? Contact us and we’ll help you kit a professional-grade installation, end to end.