Seated support — Adjustable hanger fits 5-1/2″ to 6″ beams for tight, rattle-free connections.
Ironwood durability — Pre-galvanized steel with black powder coat; ACQ-approved.
Complete kit — Includes two hanger connections, 56 OWT Timber Screws, and 12 hex cap nuts (per OZCO).
Showcase hardware — Decorative caps and finish match the Ironwood exposed-connector aesthetic.
Applications — Pergolas, porches, and outdoor rooms where seated beam support is preferred.

Ironwood 6″ Beam Hangers deliver seated, adjustable support for nominal 6″ members, tightening down to fit 5-1/2″ milled stock. The pre-galvanized steel base with black powder coat is built for weather and approved for ACQ-treated lumber, so you can spec it confidently in outdoor structures. The kit ships with OWT Timber Screws and decorative cap nuts to finish the look while providing serious holding power. Because these are part of the Ironwood family, they align visually with your truss plates, brackets, and post bases across the project. Use them wherever you want the look of exposed hardware with the function of a true seated connection.

Lay out hanger positions, dry-fit to your beam width, and start screws before drawing the hanger tight to eliminate gaps. For diagonal brace styling and hip/valley details, pair with 4″ Flush Inside 45° Angle Brackets. To cap off exposed truss nodes and keep the aesthetic consistent, add Ironwood Truss Accent Plates in visible locations.

Specifications

Beam Fit	Adjustable for 5-1/2″ to 6″ nominal boards
Material/Finish	Pre-galvanized steel, black powder coat; ACQ-approved
Kit Includes	2 hanger connections; 56 2-3/4″ OWT Timber Screws; 12 hex cap nuts
Use Cases	Pergolas, porches, exterior frames needing seated beam support

Installation (Quick Steps)

Measure — Confirm beam actual width (5-1/2″–6″).
Dry-fit — Set hanger to beam; start all screws.
Draw tight — Tighten evenly for a snug, seated connection.
Finish — Add decorative caps and re-check alignment.

Buying Guide

Member variance — Adjustable fit covers planed lumber tolerances.
System look — Coordinates with Ironwood plates/brackets/bases.
Fasteners — OWT screws included; verify counts for your span/layout.

Frequently Asked Questions

Will these fit 6x6 beams that measure 5-1/2″?: Yes—the adjustable design covers 5-1/2″ to 6″ members.
Are fasteners included?: Yes—per OZCO, the kit includes 56 OWT Timber Screws and 12 hex cap nuts.
Are they ACQ-approved?: Yes—the material/finish is approved for use with ACQ-treated lumber.

Comparison

6″ Beam Hangers (this product) — Seated connection; adjustable; kit includes screws/caps.
4″ Flush Inside 45° Brackets — Angled bracing, face-mounted (not seated support).
Standard joist hangers — Hidden hardware, different visual effect.