Flat Track Bracket for Chain Link Rolling Gate Tracks, Galvanized - Fits 1-5/8" Pipe

Product Description

Flat Back Track Bracket for Chain Link Rolling Gates — Galvanized, Wall/Flat-Mount, Fits 1-5/8″ Pipe

• Mounts Track to Flat Surfaces — Secure a 1-5/8″ pipe track to walls, wood fencing, structural steel, or masonry
• Galvanized Protection — Zinc-coated steel resists rust and weather for long service life
• Slim, Flat-Back Profile — Keeps the track close to the surface for a clean, space-saving install
• Built for Daily Use — Durable bracket body stands up to rolling gate cycles
• Professional Grade — Commonly used on residential and commercial rolling chain link gates

This galvanized flat back track bracket is designed to fasten a 1-5/8″ pipe track to any flat, vertical surface—ideal when your rolling chain link gate runs along a building, wall, or wood fence line. The bracket’s tube end sleeves inside standard 1-5/8″ rail to create a continuous track. Use brackets at regular intervals along the run (top and bottom) for a rigid, reliable rolling path that performs in all seasons.

Why Choose This

• Versatile mounting — Works on masonry, wood, or steel with appropriate anchors
• Clean alignment — Flat-back plate helps keep track straight and tight to the surface
• Low maintenance — Galvanized finish helps prevent corrosion outdoors
• Compatible — Standard 1-5/8″ pipe track component for most rolling gate systems

Specifications

Installation

Lay out top and bottom track lines along your wall or fence. Fasten a flat track bracket to the surface at regular intervals (top and bottom) using anchors appropriate for the substrate. Slide 1-5/8″ pipe over the bracket’s tube end and secure adjoining sections per your system design. Check alignment and clearance, then test-roll the gate and tighten fasteners as needed. Anchors/bolts are not included.

Buying Guide

• How many do I need? Plan one bracket at each connection point along the run, typically spaced every 8–10 ft, with one at the top and one at the bottom at each location.
• Surface anchors: Choose anchors/fasteners rated for your surface (masonry, wood, steel) and site conditions.
• Track pipe: Use standard 1-5/8″ rail to build the upper and lower tracks for your rolling gate.
• Complementary parts: Complete the system with track wheels/rollers and a rolling gate latch compatible with your framework.

Frequently Asked Questions

What pipe size does this bracket fit?

It’s designed for standard 1-5/8″ pipe (rail) used as rolling gate track.

How far apart should brackets be installed?

Spacing of 8–10 feet between bracket locations is typical. Install brackets on both the top and bottom tracks at each location.

Does it include mounting hardware?

No. Surface anchors/bolts are not included so you can select hardware suited to your substrate.

Can I mount to a wall, wood fence, or steel column?

Yes. The flat-back plate is intended for flat, vertical surfaces; use anchors appropriate for the material.

What’s the difference between this and a “universal” or “band-type” bracket?

Flat-back brackets mount to flat surfaces. Universal or band-type brackets mount to round posts using U-bolts or brace bands.

Comparison

• Flat Back Track Bracket (this item): Plate mounts to flat surfaces; ideal along walls or wood fence lines.
• Universal Track Bracket: Adjustable U-bolt design clamps to round posts; good when running track parallel to a chain link line.
• Band-Type (Brace Band) Track Bracket: Uses a brace band around the post; common on traditional post-and-rail runs.