Commercial Pressed Steel Chain Link Gate Corners, Galvanized - 1-5/8" or 2" Frame

Product Description

Commercial Pressed Steel Chain Link Gate Corners — 1-5/8″ or 2″ Frame (Galvanized)

• Pressed Steel Strength — Heavy-duty, commercial/industrial corners built for rigid frames
• Truss-Ready Design — Integrated hole accepts a truss wire or rod to combat gate sag
• Galvanized Protection — Zinc coating helps resist rust in outdoor environments
• Commercial Fit — Choose 1-5/8″ or 2″ corner size to match your gate frame
• Quick Install — Slide on, square, and secure with self-tapping screws (not included)
• Pro Setup — Use four corners per rectangular gate frame for best results

Build a rigid, professional grade gate frame with galvanized pressed steel corners that stand up to commercial and industrial use. Each corner includes a built-in truss port so you can run a wire or rod to brace wider spans and keep the latch side from dropping over time. Corners install quickly with self-tapping screws (sold separately) and are commonly used on single walk gates or double drive swing gates.

Why Choose This

• Rugged & reliable — Pressed steel construction for high-use entrances
• Integrated bracing — Truss hole simplifies anti-sag setup on wider gates
• Consistent fit — Sized specifically for 1-5/8″ or 2″ gate frames
• Long service life — Galvanized finish helps resist corrosion

Specifications

Installation

Dry-fit corners on your cut rails, then fully seat and square each corner. Secure with self-tapping screws at suitable locations on the corner. Route a truss wire or rod through the integrated hole and tension to hold the latch side up on wider gates. Install four corners per rectangular gate frame.

Buying Guide

• Select the size: Choose the 1-5/8″ corner for 1-5/8″ O.D. frames, or the 2″ corner for 1-7/8″ O.D. frames.
• Truss choice: Wire is quick and adjustable; a solid rod provides very rigid bracing—both use the same corner port.
• Pressed steel vs. aluminum: Pressed steel offers higher rigidity; aluminum is lighter and naturally won’t rust.
• Alternative builds: 3-bolt clamp corners simplify repairs; welded/mitered frames offer the cleanest, strongest permanent joints.

Frequently Asked Questions

Which frame sizes do these corners fit?

Order 1-5/8″ corners for 1-5/8″ O.D. frames, or 2″ corners for 1-7/8″ O.D. frames.

Is hardware included?

No. Use self-tapping screws to secure each corner to the rails.

Do I need a truss wire or rod?

Recommended on wider gates to prevent sag. The corner has a built-in port for easy routing.

How many corners per gate?

Four per rectangular gate frame—one at each corner.

Can I use these on double drive gates?

Yes—commonly used on commercial walk and double drive swing gates.

Are these truly “commercial” grade?

Yes—pressed steel corners are a contractor-trusted choice for high-use commercial/industrial entrances.

Comparison

Need help sizing corners or planning truss bracing? Contact us and we’ll help you pick the right setup for your gate.