Product Description
OWT Ironwood 6" T-Tie Truss Connector — 2-Pack
- 90° T-joint plate — Connects crossing members where one meets another at center.
- Heavy 3/16" steel — Hot-dipped galvanized and powder-coated for outdoor use.
- For wider members — Designed for material widths over 5-1/2" (true 6" and larger).
Make clean, rigid T-joints on pergolas and trusses when members exceed 5-1/2" wide. These 6" T-Tie plates deliver a finished look and the mass to resist racking at busy intersections; pair them with 6" Butt Joint Flush Plates on neighboring beam splices and 6" Outside 90° plates at corners for a consistent style.
Why Choose This
- Purpose-built for T-joints on 6"+ members.
- Longevity from galvanized, powder-coated 3/16" steel.
- Flexible hardware — use with OWT Timber Bolts/HCNs (sold separately).
Specifications
| Pack | 2 plates (fastening hardware not included) |
| Material / Finish | 3/16" hot-dipped galvanized steel; black powder coat |
| Design Intent | 90° T-joint for material > 5-1/2" wide |
Installation (Quick Steps)
- Layout the T-joint; clamp members.
- Pre-position plate; mark hole pattern.
- Install with OWT Timber Bolts and finish with Hex Cap Nuts (sold separately).
Buying Guide
- Member width — Use 6" plates for members wider than 5-1/2".
- Hardware — Add OWT Timber Bolts and Hex Cap Nuts for the finished look.
- System pairing — Match with outside 90° plates and rafter seams.
Frequently Asked Questions
- Is fastening hardware included with the OWT Ironwood 6" T-Tie Truss Connector?
- No. T-Tie plates are supplied as plates; use OWT Timber Bolts and Hex Cap Nuts as needed.
- What lumber sizes are appropriate for the OWT Ironwood 6" T-Tie Truss Connector?
- They are designed for connections where the receiving member is wider than 5-1/2", such as true 6" and larger beams.
- Is the OWT Ironwood 6" T-Tie Truss Connector approved for treated lumber?
- Yes. The galvanized and powder-coated finish is compatible with ACQ-treated lumber.
Comparison
- Ironwood 6" T-Tie Truss Connector (this item) — 90° T-joints on 6"+ members.
- 6" Butt Joint Flush Plates — End-to-end beam splices with low profile.
- 6" Flush Outside 90° Plates — Outside corners and frame squaring.
Warranty
See the OZCO Building Product's warranty here
