OZ-POST I2-600 24" Ornamental Post Anchor for 2" x 2" Square Posts - Individual or Cases of 6

Product Description

OZ-Post® I2-600 Ornamental Post Anchor — 2″ × 2″ Posts — 24″ Length

• No-Dig Anchor for Ornamental Posts — Drives in to set 2″ × 2″ square steel/aluminum fence posts without concrete
• Hot-Dip Galvanized Steel — Heavy 3 mm steel anchor with a black powder-coated sleeve for a clean, finished look
• Fast, Predictable Install — Use a jackhammer driver kit or manual driver; set posts and build immediately
• Secure Post Capture — Compression feature locks the post when fully driven; sleeve hardware secures alignment
• Ideal Uses — Ornamental iron/aluminum fencing, small signs, site accents where digging is impractical

The OZ-Post I2-600 is a 24″ drive-in ground anchor engineered for 2″ × 2″ square ornamental posts. Drive the anchor until only a small portion of the sleeve is above grade, then slide in the post and fasten through the pre-drilled sleeve for a neat, durable installation—no excavation or cure time required. For taller posts or heavier loads, see the deeper 34″ I2-850 alternative.

Why Choose This

• Clean appearance — Black sleeve blends with most ornamental systems
• Durability — Hot-dip galvanizing resists corrosion; rugged 3 mm steel construction
• Speed — Set multiple posts quickly with jackhammer driver kits; build the same day

Specifications

Installation

Lay out post locations and check for utilities. Using a manual driver or jackhammer driver kit, drive the I2-600 to grade leaving ≈ 3/4″ of sleeve exposed. Insert the 2″ × 2″ post; verify plumb and secure with the provided screws. Proceed per your fence manufacturer’s rail/bracket instructions. In rocky soils, pre-drill or choose an alternate foundation.

Resources: Manufacturer’s Warranty

Buying Guide

• Post height & loads: For typical ornamental panels and gates on shorter posts, I2-600 is a great fit. For taller posts or higher wind/traffic loads, consider the 34″ I2-850.
• Tools: Small runs can be installed with a manual driver; larger jobs go fastest with a jackhammer driver kit.
• Finish match: Black sleeve complements most black ornamental systems without touch-up.

Frequently Asked Questions

Do I need concrete?

No. This is a drive-in system designed to eliminate digging and concrete for qualifying applications.

Will this fit my 2″ aluminum fence posts?

Yes. It is designed for standard 2″ × 2″ square ornamental posts in steel or aluminum.

What hardware is included?

Attachment screws for securing the post to the sleeve are included.

How much of the sleeve should show above grade?

Drive nearly flush, leaving about 3/4″ exposed to access the attachment hardware.

Which driver should I use?

MDK-13 is suitable for small projects; a jackhammer driver kit is faster for larger runs.

Comparison

Unsure whether the 24″ or 34″ anchor better fits your post height and site conditions? Contact us and we’ll help you choose the right setup and driver kit for a clean, long-lasting installation.