WAP-OZ 90-Degree Inside Corner Steel to Wood Fence Brackets for 2-3/8" Steel Pipe, Fasten Ready w/ Pre-Installed Hardware

Product Description

WAP-OZ® 90° Inside Corner Steel-to-Wood Fence Brackets — Fits 2-3/8″ (2.375″ O.D.) Steel Posts

• Fasten-Ready — Ships pre-assembled with four wood screws and two carriage bolts already inserted; no parts sorting
• One Driver Size — All included fasteners use a 5/16″ hex driver for quicker installs
• True 90° Corner — Full-wrap design sits inside the fence line to join perpendicular 2×4 rails cleanly
• Outdoor-Tough — Heavy-gauge, hot-dip galvanized steel resists corrosion year-round; suitable with ACQ-treated lumber
• Time Saver — Ideal for corners, tight offsets, and odd lot lines where consistency and speed matter

Create crisp corners without custom fabrication using the WAP-OZ 90° Inside Corner Bracket. The pre-loaded hardware and single 5/16″ hex driver workflow keep crews moving post-to-post. The full-wrap bracket captures a 2-3/8″ O.D. steel post and anchors two 2×4 rails at a perfect right angle—great for wood privacy and shadowbox fences built on steel posts.

Why Choose This

• Consistent results — Factory-set layout and wrap ensure square, repeatable corners
• Less downtime — Pre-inserted hardware; no hunting bolts or swapping drivers
• Built to last — Galvanized steel bracket + coated fasteners for long outdoor service

Specifications

Installation

Slide the full-wrap bracket over a 2-3/8″ steel post and position at rail height. Seat the first 2×4 rail into the bracket and tighten the pre-inserted 5/16″ hardware with a hex driver. Repeat for the perpendicular rail, verify square and line, then continue down the run. Always fasten into sound lumber and plumb posts; follow local code and best practices for wind loads.

Resources: WAP-OZ 90° Inside Corner — Spec Sheet (PDF)  |  Manufacturer’s Warranty

Buying Guide

• Straight runs + corners: Use this bracket for corners and pair with standard WAP-OZ Steel-to-Wood Brackets for line-post rail connections.
• Budget alternative: Want lower cost and don’t need pre-assembled hardware? Consider WAP-238 Steel-to-Wood Brackets (50-Pack) — more economical, longer install time.
• Setting new posts: For a dig-less foundation on 2-3/8″ steel posts, pair with the OZ-Post IS-600.

Frequently Asked Questions

What post and rail sizes does it fit?

Standard 2-3/8″ O.D. round steel posts and 2×4 wood rails.

Do I need multiple driver sizes?

No. All included fasteners use a 5/16″ hex driver.

Is it okay with ACQ-treated lumber?

Yes. The hot-dip galvanized construction is suitable for use with modern pressure-treated lumber.

Is the hardware included?

Yes. Brackets ship with pre-inserted wood screws and carriage bolts.

Comparison

• WAP-OZ 90° Inside Corner (this item): Fasten-Ready, single 5/16″ driver, square corner connection for 2×4 rails on 2-3/8″ posts.
• WAP-OZ Line Bracket: Same Fasten-Ready workflow for straight (in-line) rail connections.
• WAP-238 Line Bracket: Similar function but not pre-assembled; lower cost with slightly longer install time.

Not sure how many corner brackets your layout needs? Contact us and we’ll help you map posts, corners, and quantities for a clean, code-conscious build.